|
2007 M.H. Moayed, R.C. Newman, Evolution of current transients and morphology of metastable and stable pitting on stainless steel near the critical pitting temperature, Corrosion Science, Vol. 48, pp. 1004-1018 (2006). 2006 Y. Huang, Y. Zhu, Hydrogen ion reduction in the process of iron rusting, Corrosion Science, Vol. 47, p. 2240-2256 (2005). 2005 E. Tada, K. Noda, S. Kumai and T. Tsuru for their paper "Monitoring of corrosion fatigue cracking using harmonic analysis of current responses induced by cyclic stressing" (Corrosion Science, Vol. 46, p. 1549-63, 2004). 2004 R. Jeffrey, R.E. Melchers, Bacteriological influence in the development of iron sulphide species in marine immersion environments, Corros. Sci., 45 (2003) 673-714 2003 Two part paper by P. Ernst and R. C. NewmanPit growth studies in stainless steel foils. I. Introduction and pit growth kinetics 44(5): 927-941, 2002 Pit growth studies in stainless steel foils. II. Effect of temperature, chloride concentration and sulphate addition, 44(5): 943-954, 2002.. 43(3): 547-578 Mar 1999. 2002 S.B Hong, N. Eliaz, E.M. Sachs, S.M. Allen, R.M. Latanision Corrosion behaviour of advanced titanium-based alloys made by three dimensional printing for biological applications, 43(9): 1781-1791, 2001. 2001 D.G. Kolman, J.R. Scully An assessment of the crack tip potential of b-titanium alloys during hydrogen environmentally assisted crack propagation based on crack tip and passive surface electrochemical measurements, 42(11): 1863-1879, 2000. 2000 A. Leng, M. Streckel and M. Stratmann: The Delamination of Polymeric Coatings from Steel Part 1 Calibration of Kelvin Probe and basic lamination mechanisms. 41(3): 547-578 Mar 1999. 1999 L. Robbiola, JM. Blengino and C. Fiaud: Morphology and Mechanisms of Formation of Natural Patinas on Archaeological Cu-Sn Alloys. 40 (12): 2083-2111 Dec 1998. 1998 N.J. Laycock and R.C. Newman: Localised Dissolution Kinetics, Salt Films and Pitting Potentials. 39(10-11): 1771 - 1790 Oct 1997. 1997 M.A. Paez, T.M. Foong, C.T. Ni, G.E. Thompson, K. Shimizu, H. Habaziki, P. Skeldon and G.C. Wood: Barrier Type Anodic Film Formation on an Al- 3.5wt% Cu Alloy. 38(1): 59 - 72 Jan 1996. 1996 R. McIntyre, D. Davidson, I.L. Walzak, A.M. Brennenstuhl, F. Gonzalez and S. Corazza: The Corrosion of Steam Generator Surfaces under typical Secondary Coolant Conditions: Effects of pH Excursions on the Alloy Surface Composition. 37(7): 1059 - 1083 July 1995. 1995 M. Stratmann and J. Muller: The Mechanism of the Oxygen Reduction on Rust-covered Metal Substrates. 36(2): 327-359 Feb 1994. 1994 A. Leng and M. Stratmann: The Inhibition of the Atmospheric Corrosion of Iron by Vapour - Phase Inhibitors. 34(10): 1657 - 1683 Oct 1993. 1993 K Hashimoto, N. Kumagai, H. Yoshioka, J.H. Kim, E. Akiyama, H. Habazaki, S. Mrowec, A. Kawashima and K. Asami, Corrosion-resistant amorphous surface alloys, Vol. 35, p. 363-370 (1993). 1992 J. Robertson: The Mechanism of High Temperature Aqueous Corrosion of Stainless Steels. 32(4): 443-465 April 1991. 1991 K.E. Heusler: Growth and Dissolution of Passivating Films. 31: 597-606 1990. 1990 R.E. Lobnig and H.J. Grabke, Mechanisms of simultaneous sulfidation and oxidation of Fe-Cr and Fe-Cr-Ni alloys and of the failure of protective chromia scales, Vol. 30, p. 1045-1071 (1990). 1989 B. Baroux: The Kinetics of Pit Generation on Stainless Steel. 28(10): 969 - 986 Oct 1988. 1988 J. Galvele: A Stress Corrosion Cracking Mechanism based on Surface Mobility. 27(1): 1-3 Jan 1987. 1987 A. Turnbull and D.H. Ferriss: Mathematically Modelling of the Electrochemistry in Corrosion Fatigue Cracks in Structural Steel Cathodically Protected in Sea-Water. 26(8): 601-628 Aug 1986. 1986 B.D. Bastow, G.C. Wood and D.P. Whittle: The Segregation of Alloy Components in Scales and Subscales formed by Binary-Alloys of Mn, Fe, Co and Ni. 25(4): 253-285 April 1985. 1985 N.J.H. Holroyd and D. Hardie: Factors controlling crack velocity in 7000 series aluminium alloys during fatigue in an aggressive environment. 23(6): 527 June 1983 |